Hi guys, i purchased this Philips soundbar a month ago. Do you have any idea how to bypass its equalizer so bass and treble will set at zero? There are 8 LED indication lights at the front panel showing you the level of bass or treble when you adjust them via remote control. I am not sure at which point would it be at zero level where bass and treble can bypass. Should I minimize them until all the lights turned off, or turn up to the middle? I believe hifi lovers would prefer bypass equalizer setting to hear its actual sound character first, before any further adjustment is made.
Philips HTL9100 How to bypass equalizer
- Thread starter radovantz
- Start date
Thank you KevinJ. You are right about resetting the soundbar to factory setting.
I have done the process right after i read your post.
Sound bar should reset the bass and treble at the same equal level. But it doen't do that. Bass is set at 5 dots, while treble is set at 3 dots. This is not an equal level point. Should i blame Philips for this.
I have done the process right after i read your post.
Sound bar should reset the bass and treble at the same equal level. But it doen't do that. Bass is set at 5 dots, while treble is set at 3 dots. This is not an equal level point. Should i blame Philips for this.
Ok. Now I test it with Iron Man 3. Seems like the sound is balance enough, although bass and treble are set at different level point, which are at 5 and 3 dots respectively.
Facebook
Twitter
Instagram