LPF for LFE

[lussen]

run audyssey denon1910 its say front& centre full band + surround & front height 80hz.what should i set speaker crossover freq and LPF for LFE freq setting.i found from audyssey web site say always set LPF for LFE at 120hz.denon1910+ms aviano2 front_aviano 5centre_sr ms avant903i_sub velodyne impact10 .

 

[Andrew Everard]

If you've run Audyssey, you shouldn't need to adjust the crossover and LPF for LFE.

 

[lussen]

for speaker crossover ok but for lpf for lfe nothing i found from 1910 set up

 

[Andrew Everard]

The set-up will set the LFE output according to the frequency response of your main speakers.

 

[JohnHolmes]

Audyssey always sets up the crossovers wrong on my M&K 750s.

I always have to return them to 80hz, sometimes sets them at 100 or 110.

 

[Ronald Archiebald]

Audyssey also tends to set all speakers to 'Full Band', i.e. Large, regardless if they are bookshelf or floorstanders.

Further manual adjustments are therefore always required.

 

[Anonymous]

I found the best setting for my setup is to set all at small and crossover at 80HZ for rear and centre and 60Hz for the fronts. the lpf for lfe i set it 120HZ. Hope it Helps.

 

[lussen]

thanks for this advice.i set my speaker crossover to 80hz n lfe 120hz now im very happy with this set up