Hi
I decided to add a third rear speaker to my set up to get 6.1 instead of 5.1. The manual states that on doing this the extra speaker outputs the combined L & R rear channels. OK.
However, despite adding this speaker in the config and being able to hear a test tone from it etc (and I can hear it when switch the tuner into 7 channel mode), it's totally silent when playing a Blu Ray and is not listed as being active on the amp's display...
Any ideas?
I decided to add a third rear speaker to my set up to get 6.1 instead of 5.1. The manual states that on doing this the extra speaker outputs the combined L & R rear channels. OK.
However, despite adding this speaker in the config and being able to hear a test tone from it etc (and I can hear it when switch the tuner into 7 channel mode), it's totally silent when playing a Blu Ray and is not listed as being active on the amp's display...
Any ideas?