Review Thoughts on the Fosi audio V3

Page 3 - Seeking answers? Join the What HiFi community: the world's leading independent guide to buying and owning hi-fi and home entertainment products.
I had the volume where it is in the picture - that’s a good point, moving the volume much below that & it cuts out. Definitely not great for quiet listening via a direct line in without independent volume control,
Thank you. That’s interesting, as I’d assumed it might need to be well advanced. I’ll probably try mine later, as curiosity is getting the better of me!
 
  • Like
Reactions: Revolutions
Sometime this year. I've never been someone who rushes things and this trait has just got worse now I've retired :)
Three line whip, Doug, get on with it!

I was surprised not to find these differences that others report. My initial reaction was it sounded a fraction dull or smoothed over, but that was literally a couple of hours from new.

I re-read the bench test on ASR, and 8 ohm speakers elicit a HF rise, whereas 4ohm (like my Sonus fabers) keep it ruler flat. Now I can scarcely hear above 11kHz these days anyway, but you guys might be hearing that. Just a possibility.

After attending the Bristol Show yesterday, I listened to my system for about three hours, so I have some reference points and know it isn’t ’out of whack’! (And I attended a piano recital in London on Friday night too).
 
Last edited:

manicm

Well-known member
I'm sure the Fosi is a good amp. But I see it like the Raspberry Pi, it's a good learning experience, and for those who want to tinker.

By the time you upgrade the power supply and op amps then you're into several hundred quid?
 
  • Like
Reactions: DougK1

Gadusmorhua

Well-known member
Jan 19, 2024
78
72
120
Visit site
I have a WiiM Pro Plus hooked up to a Mojo and a CA A1 amp from the nineties, sounds so good that visitors comment, unsolicited. Total cost £350 without speakers.
Hopefully when I upgrade from my Mordaunt M20 speakers I can enjoy an improvement, but I find them hard to fault without something to compare to.
 

DougK1

Well-known member
Jan 4, 2024
342
451
770
Visit site
I have a WiiM Pro Plus hooked up to a Mojo and a CA A1 amp from the nineties, sounds so good that visitors comment, unsolicited. Total cost £350 without speakers.
Hopefully when I upgrade from my Mordaunt M20 speakers I can enjoy an improvement, but I find them hard to fault without something to compare to.
Bravo! But this has exactly what to do with the Fosi amp?:unsure:
 
  • Like
Reactions: manicm

Gergő Csiki

Member
Apr 28, 2024
2
0
20
Visit site
I think op amp ‘rolling’ is pointless on this, but harmless fun I suppose. The larger 48v ps is all you’ll need too.
do you think that fosi v3 48v is enough for my Technics SB-C 350? I want to use them as a beginner studio monitors (I use Cubase Elements and I study film and audio editing). I don't have the money to buy active speakers to my steinberg ur22 mk2 and i also want something small so i can keep my minimalist lookig desk.
 

Amormusic

Well-known member
Mar 12, 2023
50
54
620
Visit site
do you think that fosi v3 48v is enough for my Technics SB-C 350? I want to use them as a beginner studio monitors (I use Cubase Elements and I study film and audio editing). I don't have the money to buy active speakers to my steinberg ur22 mk2 and i also want something small so i can keep my minimalist lookig desk.
Yes. I have previously owned this amp. It is small yet powerful and with a great sound. For the money it is excellent.

If you are after low-cost small form factor, this would be hard to beat.
 

Gergő Csiki

Member
Apr 28, 2024
2
0
20
Visit site
Yes. I have previously owned this amp. It is small yet powerful and with a great sound. For the money it is excellent.

If you are after low-cost small form factor, this would be hard to beat.
also i read that i don't need such a powerfull amp for sound editing in a room like 4m x 4 m (13ft x 13ft) because the speakers would be at the end of my desk (approx 1.2m from me, each). So is a 30w amp enough for me to work in Cubase while sitting at my desk?
 
do you think that fosi v3 48v is enough for my Technics SB-C 350? I want to use them as a beginner studio monitors (I use Cubase Elements and I study film and audio editing). I don't have the money to buy active speakers to my steinberg ur22 mk2 and i also want something small so i can keep my minimalist lookig desk.
I’m not familiar with studio ‘desks’ or mixers, so I’m not sure what output levels the Steinberg offers you. However, the 48v power supply gives over 100 watts into your 6ohm speakers, so for desktop use the smaller 32v version should be enough.

See the chart I posted at post #9.
 

Gray

Well-known member
Fosi 48v and SMSL on order. Me and Gray will have a play and get back with some thoughts...might take a few months.
Well it did take a few months, but patience is a virtue.

'My' Fosi V3 (and an S.M.S.L. SU-1) was delivered by motorcycle courier, in the form of DougK1 himself, on Friday. He hasn't even tried either yet, so thanks Doug (y)

My most used source is a Raspberry Pi (with a Hi-fi Berry digi+ Pro hat) playing FLAC files, via the built-in DAC of a Cyrus i7-XR integrated amp, into PMC twenty 21 speakers.

For my test, the Fosi V3 was effectively replacing the power amp section of the Cyrus integrated:
Bottom line verdict is that the V3 is unbelievable value for money.
HF, midrange and detail was on a par with the Cyrus (and that's saying something).
I found the V3 bass was slightly less defined (noticeable on leading edges) but with just a bit more body than the Cyrus - which has worked in its favour on one track so far (but only because the track featured sustained bass, rather than leading-edge, twangy stuff).

I found a mild smoothness to the sound - not a rounding off or anything negative, but what I can only describe as a lack of stridency.
Interestingly, I've subsequently re-read the thoughts of @nopiano in post #2 of this thread - where he found the sound to be 'slightly smoothed over' but 'very enjoyable' - which sums it up for me - proved by the fact that, I too, enjoyed an extended test session - there's no lack of power - even if I haven't been able to fully test that aspect yet.

Cheers for the loan Doug (y)

If I hadn't 'just' bought the Cyrus, I'd now be even more interested in some combination that included a couple of V3 monoblocks.....:unsure:
 

Amormusic

Well-known member
Mar 12, 2023
50
54
620
Visit site
These are just ridiculous VFM. They are also able to hold their own in a setup where the rest is considerably more expensive than it is, without being embarrassed, which is impressive.

As I've posted elsewhere here, I'll share my thoughts on the monos when they arrive next month.
 
  • Like
Reactions: Jasonovich

Jasonovich

Well-known member
Jul 28, 2022
1,104
672
2,070
Visit site
Well it did take a few months, but patience is a virtue.

'My' Fosi V3 (and an S.M.S.L. SU-1) was delivered by motorcycle courier, in the form of DougK1 himself, on Friday. He hasn't even tried either yet, so thanks Doug (y)

My most used source is a Raspberry Pi (with a Hi-fi Berry digi+ Pro hat) playing FLAC files, via the built-in DAC of a Cyrus i7-XR integrated amp, into PMC twenty 21 speakers.

For my test, the Fosi V3 was effectively replacing the power amp section of the Cyrus integrated:
Bottom line verdict is that the V3 is unbelievable value for money.
HF, midrange and detail was on a par with the Cyrus (and that's saying something).
I found the V3 bass was slightly less defined (noticeable on leading edges) but with just a bit more body than the Cyrus - which has worked in its favour on one track so far (but only because the track featured sustained bass, rather than leading-edge, twangy stuff).

I found a mild smoothness to the sound - not a rounding off or anything negative, but what I can only describe as a lack of stridency.
Interestingly, I've subsequently re-read the thoughts of @nopiano in post #2 of this thread - where he found the sound to be 'slightly smoothed over' but 'very enjoyable' - which sums it up for me - proved by the fact that, I too, enjoyed an extended test session - there's no lack of power - even if I haven't been able to fully test that aspect yet.

Cheers for the loan Doug (y)

If I hadn't 'just' bought the Cyrus, I'd now be even more interested in some combination that included a couple of V3 monoblocks.....:unsure:
Excellent summing up Gray, the short time I had the Fosi V3. The first thing that hit me, "Was this sound really coming out of this little box"?
The sound was expansive and lots of detail in the mid range, the bass was lean but clean, nothing bloated or lumpy. I had it for six months and by chance, somebody was selling cheap on eBay, almost new, Atoll 100 and upgraditis swayed me to part my money. I can imagine two Fosi mono's would be a formidable force.
 

TRENDING THREADS

Latest posts