Guaranteed minimum power in watts at 20 Hz-20 kHz with 0.35% THD:
2,565W (20 mS burst, 2-ohm dual per ch.), 1,800W (20 Hz-20 kHz, 2-ohm dual per ch.), 1,800W (1 kHz, 2-ohm dual per ch.), 2,000W (4-ohm dual per ch.), 1,250W (8-ohm dual per ch.), 3,600W (4-ohm bridge), and
4,000W (8-ohm bridge).Frequency Response (at 1 watt, 20 Hz - 20 kHz into 8 ohms): ±0.25 dB.Signal to Noise Ratio (below rated full-bandwidth power, A-weighted): > 110 dB. Total Harmonic Distortion (THD) (at 2 watts into 8 ohms): < 0.1%. Total Harmonic Distortion (THD) Plus Noise (at full rated power): < 0.35%, 20 Hz to 20 kHz.Intermodulation Distortion (IMD) (60 Hz and 7 kHz at 4:1, from full rated output to –30 dB): < 0.35%.
Damping Factor (20 Hz to 100 Hz at 8 ohms): >
5000.Crosstalk (below rated power, 20 Hz to 1 kHz): > 80 dB.Common Mode Rejection (CMR) (20 Hz to 1 kHz): 55 dB, typically >70 dB.DC Output Offset (shorted input): < ± 3 mV.Input Impedance (nominal): 10 kilohms balanced, 5 kilohms unbalanced.Maximum Input Level: +20 dBu typical.Network: Onboard HiQnet, compatible with standard 100 Mb Ethercom hardware.
Load Impedance: (Note: Safe with all types of loads)Stereo:
1/2/4/8/16 ohms.Bridge Mono: 2/4/8 ohms.Input Sensitivity (referenced to 8 ohm rated output): 1.4V, 32 dB gain, and 26 dB gain.Voltage Gain (referenced to 8 ohm rated output): 37.1 dB to 22.2 dB Required AC Mains: Universal AC input, 100-240VAC, 50/60 Hz (±10%). Maximum AC mains voltage 264VAC.AC Line Connector: Five cordsets supplied with amplifi er (USA, UK, European, Australia, India).Amplifier shall be protected against reactive loads, faults and shorts. If one channel experiences a catastrophic failure, the entire amplifi er will shut down.The front panel shall be cast aluminum, with integrated handles. Cooling shall be dual-zone, microprocessor controlled, continuously variable speed fans, front-to-back airflow.Dimensions shall be EIA Standard 19-in. rack mount width (EIA RS-310-B), 3.5 in. (8.9 cm) high and 16.2 in. (41.1 cm) deep.Net weight shall be 28 lb (12.7 kg). Shipping weight shall be 36 lb (16.3 kg). The amplifier shall be designated the
Crown Macro-Tech 5000i.