Can a voltage converter/transformer be used with a 110v Onkyo AVR

[Ralph993]

GF is moving over from Canada and has an Onkyo TX-NR809 but it uses 110v power and we 220v over here. I have a transformer, would it be safe to use one on an AVR so that it can run on 220v? Any advice appreciated

 

[Juzzie Wuzzie]

Sell it, buy something new here. Once you factor in hassle and faff factor, it is probably a break even trade. Additionally, and I'm guessing here, the size of accommodation you'll have here will be smaller than in Canada, so that might change the approach you would take to home cinema.

 

[Andrew Everard]

Provided the transformer has sufficient capacity for the Onkyo – it's rated at about 900W peak consumption, or 7.5A/120V – it should be fine.

 

[Ralph993]

The room is 12m x 6m so not exactly small...

Thanks for the input on the transformer sizing, I'll be sure to check on that

 

[Juzzie Wuzzie]

Not exactly - about 20m2 bigger than my whole flat!

 

[bigboss]

Additionally, and I'm guessing here, the size of accommodation you'll have here will be smaller than in Canada, so that might change the approach you would take to home cinema.

Never assume anything.

 

[chudleighpaul]

The Canadian mains is 60hz so even if you had a transformer it is possible that you would have problems with a 50hz supply over here. Best advice is sell it and buy new here.