Use of switch and galvanic isolation between router and streamer.

[Jens Mortensen]

Has anybody experience with placing a switch between router and streamer? And what about a galvanic separation?
Regards Jens.

 

[Vincent Kars]

Have you ever seen measurements at the analog out of a streamer demonstrating lower noise floor, better jitter performance, lower IMD when using otical, audiophile ethernet cable, linear psu, audiophile switch?
Neither do I.

 

[nopiano]

Yes, I put a Netgear GS108 switch after my ISP’s modem/router and before my streamer. Linn recommend it and it’s a modest price. I later learned that the results are likely to be optimised if the switch is close to the streamer, so the Ethernet cable runs 10metres from hall to listening room (living room) then I use a 1m cable from switch to the streamer. That last length is unshielded and with plastic plugs to ensure a break from any unwanted noise entering the streamer.

My hearing is no longer acute enough to verify by listening whether the difference is audible, so I simply see it as good housekeeping. 🙂

 

[Revolutions]

I’ve been meaning to try it. But never gotten round to it as my system sounds pretty damn good as it is.

 

[Dave_]

Has anybody experience with placing a switch between router and streamer?

Entirely pointless, unless of course your router doesn't provide enough ethernet ports.

And what about a galvanic separation?
Regards Jens.

What about it?

Galvanic isolation is part of the ethernet spec...