how to bi wire my speakers?

[markyboy156]

hi i have the onkyo nr5008 amp and a 7.1 monitor audio silver rs6av speaker package the (older series speakers? i was told that you can bi wire the fronts centre and rears on this speaker package is this correct? and if so could i bi wire the front centre and rears to the onkyo nr5008 or could i only bi wire the front speakers need help asap please

 

[markyboy156]

could somebody reply asap please

 

[duaplex]

Bi-amp the fronts and Bi-wire the center. Same as what i have in my signature. Its sounds very good!

 

[sta99y]

Take the binding connecter off the speaker terminal and run 2lengths of wire from 1 output on amp. Connect 1 run to lower speaker connecter and other to the top one. Do same with others.

 

[duaplex]

Remove the bridge on the back of your speakers, otherwise they will blow. Then connect two wires to the positive terminals. Twist the opposite ends together and plug into positive on AV. Do the same for Negative.

Done

 

[markyboy156]

hi can you bi wire the rears as well for the rs6 av package?

 

[fayeanddavid]

Bi-amp the fronts and Bi-wire the center. Same as what i have in my signature. Its sounds very good!

Done the same on my set up, also sounds soooo good!

 

[fayeanddavid]

hi can you bi wire the rears as well for the rs6 av package?

If there are two sets of speaker terminals on each speaker then Yes.

If not.................No

 

[Big Chris]

Bi-amp the fronts and Bi-wire the center. Same as what i have in my signature. Its sounds very good!

I know the 5008's a monster of an amp, but can it bi-amp the front speakers while running in full 7.1 mode?

 

[duaplex]

I think the best bet is to buy an Amp to power the mains and then free up the AV for 7.1