Using an SPL to setup speakers

[skularatna]

I have a question, as I think i may have made a mistake. I set my SPL to C weighted slow response. The SPL has two displays. One is input level which i think shows how loud the speakers are. There is also a "Relative" display.

When setting the speaker levels should the test tone for each speaker read 0 on the Relative?

 

[Andrew Everard]

Not sure which meter you're using, but it sounds like it lets you take one reading, then subsequent ones are measured relative to the first.

So if you want all the speakers at the same level, then yes, 0 on the relative scale after the initial measurement.