Speakers break in period

FBech

Well-known member
Oct 29, 2024
29
2
45
Hello, I just got a pair of whaferdale diamond 12.3. They are not sounding as good as in the shop, lack of bass mainly.

It is true that speakers have a break in period?
 

abacus

Well-known member
Sep 24, 2008
1,325
1,138
21,070
Find a recording of pink noise (Mono), then place the speakers approximately 1m apart facing each other, then connect the one speaker out of phase, play the pink noise for about 4hrs or so (Be careful with the volume so that you don't overload the speakers, as the out of phase noise cancelling effect will make it seem quieter than it is) and you will be good to go, after that experiment with positioning to get the best performance. (Don't forget to reconnect the speakers back correctly)

Bill
 
  • Like
Reactions: Jasonovich

Gray

Well-known member
Mainly due to different room = different sound.
The acoustic properties of the room are a much underestimated phenomenon.
✅ MUCH more underestimated than any 'break in' effects - which are often vastly overestimated.

Some people wait for the effects of the magical break in and buy fancy speaker cables......after placing speakers in echo chamber rooms 🤪
 

Jasonovich

Well-known member
Jul 28, 2022
1,987
1,345
4,570
Hello, I just got a pair of whaferdale diamond 12.3. They are not sounding as good as in the shop, lack of bass mainly.

It is true that speakers have a break in period?
This may be particular to your room, setup and positioning.
I'm not sure where I stand with speakers breaking in, but I don't think this will change much.
I would suggest getting yourself a subwoofer.
If you don't have deep pockets for Rel or SVS, you could consider Velodyne SP2 8 inch, SW.
I have these setup with the Kilpsch in the diner room hifi. They don't add any colour to the sound and very good.
 

ToppingSMSL

Well-known member
Oct 10, 2024
121
66
170
✅ MUCH more underestimated than any 'break in' effects - which are often vastly overestimated.

Some people wait for the effects of the magical break in and buy fancy speaker cables......after placing speakers in echo chamber rooms 🤪
There's a guy on youtube who buys "fake" audiophile cables from aliexpress (Nordost, Audioquest etc) and does an initial review looking at the construction quality etc and explains he still needs to burn them in and does a proper review after the burn in is complete :D
 
  • Like
Reactions: Gray

abacus

Well-known member
Sep 24, 2008
1,325
1,138
21,070
Speakers are mechanical, hence the need for running in, electronics, leave them on for a couple of minutes to allow them to stabilise and you are good to go, (Note: Tube amplifiers take a lot longer) cables, well that has been debunked so many times, I am surprised how many people still believe it.

Bill
 
  • Like
Reactions: Jasonovich

nopiano

Well-known member
Hello, I just got a pair of whaferdale diamond 12.3. They are not sounding as good as in the shop, lack of bass mainly.

It is true that speakers have a break in period?
What are you connecting them to, and are you sure they are in phase? The main symptom of out of phase speakers is lack of bass, followed by lack of a focussed image.

What did they replace?

Were they played immediately after collecting from a cold warehouse, or transported in a cold car? Speakers can sound a bit ‘stiff’ if they haven’t been at room temperature for a few hours.
 

ToppingSMSL

Well-known member
Oct 10, 2024
121
66
170
Speakers are mechanical, hence the need for running in, electronics, leave them on for a couple of minutes to allow them to stabilise and you are good to go, (Note: Tube amplifiers take a lot longer) cables, well that has been debunked so many times, I am surprised how many people still believe it.

Bill
Whilst it may be possible that some drivers change over time here is an interesting headphone break in experiment which found no difference:


I'm certainly not going to say there is no such thing as driver burn-in, but when you think about it it's a bit odd - they're designed to be reactive to an electrical signal and you'd expect them to be designed in such a way that there is very minimal change from when they are manufactured. If a company finds that there is a big difference why wouldnt they break them in themselves before shipping?
View: https://www.youtube.com/watch?v=zo4P48Y9BJw
 

Al ears

Well-known member
Whilst it may be possible that some drivers change over time here is an interesting headphone break in experiment which found no difference:


I'm certainly not going to say there is no such thing as driver burn-in, but when you think about it it's a bit odd - they're designed to be reactive to an electrical signal and you'd expect them to be designed in such a way that there is very minimal change from when they are manufactured. If a company finds that there is a big difference why wouldnt they break them in themselves before shipping?
View: https://www.youtube.com/watch?v=zo4P48Y9BJw
If anything it is the stiff runner surrounds on many speakers that need time to aclimatise and break in rather than any electronics.
 

TRENDING THREADS

Latest posts