Question Lector - Harbeth

[telemann]

Hello everyone. I have a CDP Lector 7 TL connected to the Lector Zoe preamp and two VM200 monoblocks, Harbeth 5 SHL XD speakers (not the XD2!). I'm looking for advice on signal and power cables to maintain a warm, bright, and powerful sound. I'm using them VDH 102 Mk III, Cardas crosslink Cable talk Interconnect, Ricable Speakers now, but I'm not very satisfied. Impeto Audio e Oehlbach,?Thanks. P.S For the Harbeth loudspeakers stands? Atacama?

 

[Revolutions]

What is it you're not enjoying about your setup? You've got some excellent units, although when I demoed Harbeth SHL5 speakers, powerful & bright wasn't their M.O. I found them warm & gentle. That's just my opinion, of course.

I'm strongly of the belief interconnects will make no discernible difference to your sound vs a basic quality level, most certainly power cables.

My recommendation would be to play with speaker positioning in the first instance to see if that helps.

 

[telemann]

Thanks for your attention. Are you sure cables aren't that important? The power cables are all Supra. I'm looking for good signal and speakers cables for the connections and suitable stands...

 

[Al ears]

For stands I quite like these:-

Harbeth SuperHL5 Plus Speaker Stands 140-900mm (Pair)

Enhanced Audio.Elegant and Iconic.Strong, Stable Self leveling three leg Design.Designed specifically for Harbeth SuperHL5 Plus Speakers with a top plate measuring 322mm Wide x 300mm Deep.Imagine your Harbeth Reference Point positioned perfectly for your optimum listening position, Sit back...

audiochic.co.uk

I will not, however, be getting into a cable debate.

 

[telemann]

Ok Atacama sxl 400 Tontrager? Tontragers are really expensive, are they really worth it? Are there any audible positive differences compared to other stands?

 

[Revolutions]

Are you sure cables aren't that important?

As per Al, I don't want to derail this thread with a cable debate. In my opinion, you have more than good enough connectors already.

The truth is: if you think cables matter, you might hear a difference by changing them

 

[telemann]

Maybe, or rather, almost certainly, you're right... There are tons of cables available at a wide range of prices, but perhaps a "normal" copper cable should be suitable for all seasons... or not? But...Tontrager stands? other steel stands and much cheaper?

 

[Al ears]

Ok Atacama sxl 400 Tontrager? Tontragers are really expensive, are they really worth it? Are there any audible positive differences compared to other stands?

I very much doubt it.
Getting the correct height is critical as is positioning, both of these will make a bigger difference to the type of stand they are sat on.
What type of flooring are the stands being placed on?

 

[telemann]

On normal ceramic tiles..The Tontrager (recommended by Harbeth) are too expensive and I'm not sure they are worth all that money..With Stand Atacamo slx 400 (or another brand 45 cm high) should I get good results, or not?

 

[Al ears]

On normal ceramic tiles..The Tontrager (recommended by Harbeth) are too expensive and I'm not sure they are worth all that money..With Stand Atacamo slx 400 (or another brand 45 cm high) should I get good results, or not?

On ceramic tiles where? On a suspended floor or a solid concrete one?
Your best bet , in my opinion, is to buy cheaper stands but put isolation feet like Isoacoustics or similar under the stands, Stack Audio Auva are also excellent.
Forgot the over expensive Tontragers.
Get this right and you can stop being concerned about expensive cables.
From personal experience removing the spikes from under my main speakers and replacing with Isoacoustic Gaia isolators was the best money I have spent in a good while.
However that's just me.

 

[Gray]

Are you sure cables aren't that important?

The majority of people are.

perhaps a "normal" copper cable should be suitable for all seasons...

✅