What to do what amp.?

[admin_exported]

Hi all as you can see my user name states it all I have just had a clear out and and want to start again so what I have left is two Nad monitor series 2400 power amps and an old yam pre amp model e800 I want to play my tunes through my iPod iPhone can I do this with this old pre amp.?Next question is this pre amp suited to these power amps.Next question can I run small speakers with a separate sub.?If I need to buy a new pre amp this is no problem.Many thanks SImon.

 

[Anonymous]

Here's the spec of the amp taken from the NAD website:

POWER AMP SECTION

Continuous output power into 8½ * 100W (20dBW)

Rated distortion (THD 20Hz - 20kHz) 0.03%

Clipping power (maximum continuous power per channel) 130W

IHF Dynamic headroom at 8½ +5.7dB

IHF dynamic power (maximum short term power per channel) 8½ 370W (25.7dBW)

4½ 400W (26dBW)

2½ 440W (26.4dBW)

Damping factor (ref. 8½, 50Hz) >100

Input impedance 20k½ / 600pF

Input sensitivity (for rated power into 8½) 1V

Frequency response 3Hz - 100kHz / +0, -3dBdB

Signal/noise ratio ref. 1W 98dB

ref. rated power 118dB

THD (20Hz - 20kHz) <0.03%

Bridged Mode

Continuous output power into 8½ * 200W (23dBW)

IHF Dynamic headroom at 8½ +6dB

IHF dynamic power (maximum short term power per channel) 8½ 800W (29dBW)

4½ 880W (29.4dBW)

PHYSICAL SPECIFICATIONS

Dimensions (W x H x D) 435 x 127 x 385mm

Net weight 10kg

Shipping weight 12kg

Power consumption (120 ~ 240V, 50/60Hz) 390VA

* Minimum power per chnnel, 20Hz - 20kHz, both channels driven with no more than rated distiortion.

Dimensions are of unit’s cabinet without attached feet; add up to 18mm for total height.

Dimension depth excludes terminals, sockets, controls and buttons.

© NAD