I just got a pair of 10 years old QED XT-400 speaker cables from my friend. I wonder if it's still good? What is the lifetime for speaker cables? Any maintenance for speaker cables?
Lifetime for speaker cables? Any maintenance for speaker cables?
- Thread starter admin_exported
- Start date
Yup will be fine. Only thing when they get old and exposed to the air, the copper/silver wire can tarnish, which aparently might be a degradtion of the contact.
jjbomber said:
A quick dip in a bath of warm water, salt and vinegar (as in table salt and Sarsons, not crisps) (yes, honestly - it creates hydrochloric acid - NaCl + CH3COOH --> NaCH3COO + HCl ) will remove any tarnish. Rinse thoroughly in fresh (tap) water afterwards and remember to run the tap when disposing of the water/salt/vinegar mix, especially if you have a stainless steel or aluminium sink....
Excellent. A real man should always be able to make his own acid.🙂 How many readers are tempted to stop what they are doing and go and make some straight away?Benedict_Arnold said:
hammill said:
It was a tip I got building radio-controlled planes a few years ago, preparing stuff for silver-soldering.
Just don't ask what a university classmate from Belfast told me he could do with a bag of fertiliser, and [the rest of this post has been redacted on the grounds that some stupid idiot might actually try it]....
chebby
Well-known member
- Jun 2, 2008
- 1,257
- 34
- 19,220
Benedict_Arnold said:
Oh we've all done that. Powdered aluminium and diesel etc. Who hasn't blown up the odd chemistry classroom or three when a lad? Ah, what larks.
Teller-Ulam multi-stage nukes are the hard ones. Dry rooms for the Lithium-6 Deuteride are expensive and you try getting hold of a robotic facility to machine the hollow Plutonium spark plugs. (The council goes bananas when highly radioactive swarf is left in their recycling bins so you can't do it at home!)
Covenanter
Well-known member
- Jul 20, 2012
- 101
- 59
- 18,670
I don't think I can bear the tension much longer! Surely somebody is going to post that they wear out (because the electrons in them get tired or some similar hocus pocus).
Chris
Chris
Covenanter said:I don't think I can bear the tension much longer! Surely somebody is going to post that they wear out (because the electrons in them get tired or some similar hocus pocus).
Chris
It's actually called hydrogen embrittlement, and as well as being a problem familiar to all welders, is a real phenomenon in (over-)cathodically protected underwater structures, I'll have you know. BP had to pull two effin' great subsea manifolds from the bottom of the Gulf of Mexico, in water about a MILE DEEP, because of this back in 2003 or 2004.
As for copper (lifted straight from Wiki so it must be true)...
Copper alloys which contain oxygen can be embrittled if exposed to hot hydrogen. The hydrogen diffuses through the copper and reacts with inclusions of Cu2O, forming H2O (water), which then forms pressurized bubbles at the grain boundaries. This process can cause the grains to literally be forced away from each other, and is known as steam embrittlement (because steam is produced, not because exposure to steam causes the problem).
QED running your hifi at 11 out of 10 on the dial in a sauna might not be a good idea.
SO THERE (insert mooning smiley here)
Covenanter said:I don't think I can bear the tension much longer! Surely somebody is going to post that they wear out (because the electrons in them get tired or some similar hocus pocus).
Chris
I'm wearing out due to a surfeit of free-radicals! :shifty:
Facebook
Twitter
Instagram