Can I Bi-Amp my Arcam Solo Movie 5.1?

jimmylee73

New member
Aug 4, 2011
10
0
0
Visit site
i have just consulted the arcam website along with the manual and it appears it is possible to do. does anybody have any experience of doing this? any sound improvements to be had?
 

Bodfish

New member
Jun 25, 2009
16
0
0
Visit site
Can you explain where in the manual you have found reference to this functionality? I had a scan through it yesterday and like Andrew, can find no mention of it at all.
 

jimmylee73

New member
Aug 4, 2011
10
0
0
Visit site
hi bodfish

yes, i found the following reference on the arcam site; http://www.arcam.co.uk/advice-and-support/faq/solo-movie.htm

Is it possible to Bi-Amp the Solo Movie?

The Arcam Solo 5.1 has a rear panel set of discrete 5.1 pre outs which can be connected to Arcam power amplifiers (such as the P35) for Bi-Amping. However, if you are not using rear channels in your system it is also possible to internally re-route the rear speaker power amplifiers for Bi-Amping the front channels. This is performed by a simple adjustment within the software (See Handbook page 19 - Powered Surround Configuration) for details.
 

jimmylee73

New member
Aug 4, 2011
10
0
0
Visit site
hi bodfish

yes, i found the following reference on the arcam site; http://www.arcam.co.uk/advice-and-support/faq/solo-movie.htm

Is it possible to Bi-Amp the Solo Movie?

The Arcam Solo 5.1 has a rear panel set of discrete 5.1 pre outs which can be connected to Arcam power amplifiers (such as the P35) for Bi-Amping. However, if you are not using rear channels in your system it is also possible to internally re-route the rear speaker power amplifiers for Bi-Amping the front channels. This is performed by a simple adjustment within the software (See Handbook page 19 - Powered Surround Configuration) for details.