Recent content by valkodav

Hello guys. Lets get straight to the topic: Does different DACs change the quality of the sound in a particular system? How does the DAC affect the sound quality? Do they improve the sound or we just give too much attention on that topic? Thanks.

No haven't changed any settings. It 2 years old. Not sure about warranty.

Hi there, I am having problem with my dune hd base 3D. It stopped playing music properly. When listening to 2 channel audio it sounds very very low. Also FLACS. It only plays multichannel audio properly at normal listening level. Yesterday i did a firmware upgrade and i don't know whether...

Hi there, I am having problem with my dune hd base 3D. It stopped playing music properly. When listening to 2 channel audio it sounds very very low. Also FLACS. It only plays multichannel audio properly at normal listening level. Yesterday i did a firmware upgrade and i don't know whether if...

Hello, I am meeting some difficulties in understanding the relation between input sensitivity, gain, output voltage. I have a source rated at 2V output voltage, an amp with input sensitivity of 1.25V (8volts maximum) and gain of 29dB. Im thinking of buying preamp with output voltage of 1V...

Hello, I have speakers that are rated to recomended amp powe of : 40-250W. Will they be suitable if paired with amp rated at 2x250W at 8ohm ? I am asking because it's just on the edge. Thanks.

What about preamp gain ? Im confused.

Hi, How to choose preamp for power amp. What specs should i look for ?

No it doesn't show any ATT message only the OVER in blinking red .

Hi there guys, I have pioneer sc-lx 86 avr, when i am listening to any analog input ( also with multichannel analog ins), i am getting message on the display of the avr, saying OVER and sometimes it is blinking. Couldn't find any infor on the subject in the manual. Should i worry about that ...

Thanks guys, helped a lot, now everything is clear.

Hello guys, I would like to know how to calculate the amp's pwoer output at different ohm loads. For example lets say that i have and amp rated at 2x200W @ 6ohm load. How is this value going to change if i connect speakers with 8ohm impedance. How to calculate that ? Thank you.

Nevermind i fixed the problem myself. Now i am going to do a handjob. Then i will wash my armpits because they are a bit sour with sophisticated musk odour. After i do these routine procedures i am going to call a hooker for nuru massage. Bye gayboys.

I cant find a way to tell them