M&K X36 Xenon speakers need stands!

[admin_exported]

M&K X36 Xenons being used as front to speakers for home
cinema need stands. They seem to be too small for the floor stands and
too heavy for the 'satellite' stands. M&K used to make some stands a
few years back, but not with the new company set up. The old stands can
be seen here:

http://www.homecinema.uk.com/files/MK_brochure2005.pdf

Does anyone have any they are selling?!

Dimensions (HxWxD). . . 9.5” x 3.9” x 5.9” - 24 x 9.8 x 15 cm

Weight. . . . . . . . . . . . . . . . . . . . . . . . . 5 lb/2.3 kg

I was wondering if anyone owned these and had found anything suitable.
We're not ready to wall mount them yet! Too much paintwork!

Thanks in advance.

 

[lobby]

I had the same problem with my Quad-lites and several shops advised me to look at Apollo. They suggested the Apollo Sat with a top plate of 90mm x 120mm and height of 900mm, the Quads are 135mm x 150mm and i didn't like the overhang also expensive at over £100, but may be suitable for you as yours are only 98mm wide, Alternatively are the Apollo A1 which i went for top plate 125mm x 150mm x 700mm fits perfectly at £45 a pair. This might help you a bit.

 

[Frank Harvey]

The stands shown in the picture are some Spectral stands, which were distributed by M&K's UK distributor for a short while. I think the model number was BS88, and they were around £150/pair. I believe they're still available through Spectral dealers.

The Apollo Sat 1 is a good alternative, which should come with a top plate and an extra plate to fix the speaker directly on to them.